日本語解説はこちら

This section describes How to SettingUp  WayPoint (WP) 

Please follow the instruction below.
WPScreen is to add the waypoint on your flight route.
All the data and info(Location Altitude etc) must be obtained from on-line service, so internet hookup capability is must (such as 3G or WiFi).
WayPoint (WP) setting up should be done at the place where no communication failure occurs.

Moving the map ( Enlarge Reduce )
Enlarge, Reduce can be done with Pinch in/Out
Please drag the map to move the location on the screen
To go back to current position, tap the “Current position” button.

Adding WayPoint (WP)
Just double tap the location on the map, then red marker appears.
At the same times, the sea level altitude is obtained through on-line network.
You will see the blue line by adding more Waypoint.  The line will be your flight route.

To delete the Waypoint
just tap the red marker. Select “Delete” on the window
The Elevation of the point also appears on the window

To delete all waypoint
Tap the “Remove All WP” on the screen, Then, “Remove All WP”? will appear.

To save  WayPoint
After you done adding Waypoint, just tap the “WP Save” button to save all that.
WayPoint still appears on the NAV screen without doing “WP Save” but if the system shut down, You must need to set it up again.